home  |   news  |   FYI  |   products  |   tools  |   contact us  |   locate a dealer  |   HIPPO End Users

HIPPO News
Related/Industry News

Tiger Tooth Saw Blades

MHE is proud to be a distributor for US Saws, "Tiger Tooth" blades. If you haven't seen or used one yet, you are in for a pleasant surprise!

The "Tiger Tooth" blade easily cut through 7/8" thick cast iron in approximately 1-minute

The blade pictured above is a 14" Tiger Tooth blade (manufactured by U.S. Saws, Inc.) Combined with the incredible power of a Stanley CO25, hydraulic cut-off saw, the results are impressive, to say the least!

Specs
14" "Tiger Tooth" Super Grit Diamond Blade The "Tiger Tooth" is a vaccuum-brazed, electroplated, "step segment" blade with oversized diamond-grit & wear-resistant swirled sides. It is designed to cut all materials:
  • Cast Iron
  • Ductile Iron
  • Concrete
  • Reinforced Concrete
  • Clay
  • Aluminum
  • Steel
  • Copper
  • Wood
  • PVC
  • Etc
It is ideal for emergency fast cutting use and multi-use situations.

Stanley CO25 Cut-Off Saw with
Stanley CO25 Cut-Off Saw with "Tiger Tooth" blade

And here's some information about the Stanley CO25 Hydraulic Cut-Off Saw
Lightweight (approx 25lbs with blade) and powerful, the Stanley CO25 Cutoff Saw (p/n# 205541) is ideal for cutting concrete, masonry, pipe, structural steel beams and guardrail. The CO25 can be used with readily available 14 inch abrasive or wet and dry diamond blades. Available Handle Extension Kit (p/n# 34175) provides for upright operation to meet operator preference
The CO25 is a 9-Horsepower tool! Only hydraulic tools can put that kind of power into your hands. No other tool even comes close!

All (current) HIPPO products allow an operator to use a hydraulic saw AND another tool (such as a trash pump, or a generator) at the same time!

Click on the image to see the Tiger-Tooth blade on a Stanley CO25 saw, in action!


Stanley CO25 Cut-Off Saw with
One bad saw-blade!

Why should you care about any of this?

We found out from the guys at MLGW that they had recently tried to cut a section of pipe just like this, but it had taken them nearly 6-hours, and they went through 4 (gas powered) saws doing it. The guys were choking and gagging on fumes the entire time, and they had to constantly worry about getting the saw in the water. The ironic thing is that they have hydraulic power, they have a Stanley CO25 cut-off saw, and they had that blade! They didn't have to suffer like that!
  1. Hydraulic tools don't produce any fumes. They could run that saw in a coat closet and not be affected by fumes!
  2. Hydraulic tools don't mind the water. The CO25 cut-off saw can be operated in and even under water.
  3. Power! Once again, generally speaking, the majority of hydraulic tools are 9-HP tools! Compare that to the biggest, baddest, gas-powered quickie saw (Stihl TS 800), which only has 6.7-HP


Mobile Hydraulic Equipment Co., LLC   1544 Howell, Kansas City, MO 64116
Phone: 816-474-2034   Fax: 816-474-7447   Toll Free: 800-844-0624